Table of Contents
Advertisement
Wiring plan, connecting
the signal processing
unit and the power
supply
(see also "Application
example")
DC polarity indifferent
Be careful the polarity of
the cables
Checking the
Connections
16
5.5. Connecting the signal processing unit and the power supply
The following figure shows the wiring plan, connecting the signal
processing unit and the power supply:
The output must be current only or must be voltage only, can not
use both. The unused connector must be unconnected.
Factory default: Current output. When change it to voltage output
must be change the settings by the DT1102V_D.exe configuration
program.
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to the wiring
plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
Check if the cables are connected properly (have you connected all
the cables, have you connected to the right place, do not the cable-
ends touch each other).
DT1102 V
20230127-V0
Advertisement
Table of Contents
