Table of Contents
Advertisement
DT1102 V
5.7. Connecting to PC via USB cable
The following figure shows the
USB connector on front of the instruments.
1. For the communication between PC and instruments plug the accessory
USB cable (USB-B mini, 5 pins) to USB connector (1).
2. See the chapter Hiba! A hivatkozási forrás nem található. for settings.
3. After the settings unplug the USB cable from instruments.
The USB port is galvanic isolated therefore the USB cable can
plugged into a grounded PC too. When USB cable connected or
unplugged to instrument need not switch off the power supply.
18
20230127-V0
Advertisement
Table of Contents
