Wiring plan, connecting
the DC voltage signal
source
(see also "Application
example")
Be careful the polarity of
the cables
Checking the
Connections
14
5.3. Connecting a -2.5 - +2.5 VDC voltage signal source
The following figure shows the wiring plan, connecting the DC voltage
signal source:
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to the wiring
plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
Check if the cables are connected properly (have you connected all
the cables, have you connected to the right place, do not the cable-
ends touch each other).
DT1102 V
20230127-V0