Advertisement
STRIKE PLATE
(M38 Shown)
STRIKE BUSHING
(2-3X) RUBBER
WASHERS
3 1/4
DRESS COVER
(MAX.)
LOCK HOUSING
(M38 Shown)
(2X) #14 X 1-1/4"
LONG SLOTTED HEX
WITH WASHER HEAD
TYPE "A" SCREW
Notes for TJ and Z-Bracket locations:
1) When positioning the lock assembly, the center of the magnet must be located within the 3-
1/4" area from the edge of the door opening. This will provide adequate room for the strike
mounting hardware on the Z-Bracket. (See Figure 3).
2) The Z-Bracket is the same width as that of the lock/TJ-Bracket assembly on the door frame.
This relationship (width edge-to-edge alignment) must be maintained for proper installation.
3) Prior to drilling holes in the door, double-check to confirm that there is adequate space to
drill the three (3) holes required in the long leg of the Z-Bracket for the strike mounting. (At
this point the Z-Bracket may also be used as a template to mark the three (3) mounting hole
locations for drilling the door).
5. LOCK INSTALLATION
INSTALLER
FABRICATED SHIM
(As Required)
TJ-BRACKET
T-NUT
5/16-18 UNC SOCKET
HEAD CAP SCREW
Z-BRACKET
Figure 3
Figure 4
Page 3
TJ-BRACKET
MOUNTING HARDWARE:
(6X) #14 X 4" Long
Flat Head Type "A" - OR
(6X) #12 X 1-1/2" Long
Flat Head Type "A" - OR
(6X) 1/4-20 X 1-1/2" Long
Flat Head Machine Screw
(With 1/4-20 Blind Nuts)
(DOOR FRAME)
(HEADER)
(DOOR STOP)
5/8 (MIN.)
SEX BOLT
(DOOR)
PN# 500-19900
Rev. F, 04/11
Advertisement
