Prepare Lock For Installation - Assa Abloy Yale inTouch Installation And Programming Instructions

Unpack the Lock
The lock is packed representative of how it will install on the door.
Before installation:
A. Disassemble the inside escutcheon
1. Remove the inside lever with the lever removal tool provided
2. Separate the inside support assembly from the inside escutcheon
B. Remove the battery cover
1. Unscrew the hex screw using the Allen wrench provided. The hex screw does
not come completely out.
2. Slide the battery cover off.
The outside assembly stays assembled.
Inside
Support
Assembly
Determine Hand of the Door
Face the door from the secure side to determine it's hand.
The secure side is the touchscreen side of an entrance door or the corridor side of a room door.
Note: inTouch locks are non-handed; the lever can be flipped around to the desired handing.
Left Hand Reverse
Hinges on left.
Opens outward.
For handed locks,
specify LHR.
An ASSA ABLOY Group brand

PREPARE LOCK FOR INSTALLATION

Support
Escutcheon
Assembly
Screws
Left Hand
Hinges on left.
Opens inward.
For handed locks,
specify LH.
Inside
Battery
Cover
Right Hand
Hinges on right.
Opens inward.
for handed locks,
specify RH.
Inside
Lever
Handle
Right Hand Reverse
Hinges on right.
Opens outward.
For handed locks,
specify RHR.
5
P/N 80-9150-0065-010 Rev B