Table of Contents
Advertisement
MAINTENANCE OPERATIONS TO BE CARRIED OUT BY THE USER
Before perform any maintenance operation on the machine, disengage the cutting blade, stop the
engine, lock the parking brake and remove the ignition key. Do not let anybody approach the driving
If maintenance operation are not made, damages can occur to the machine and personnal injuries to the user
and/or spectators. These damages and injuries will not be covered by the warranty.
Daily maintenance will be performed by the user.
Maintenance operations for first 20 hours, 100 hours and 300 hours should be realized by the dealer.
Ask your dealer to check the machine if you meet some problems.
Ask your distributor the name of your dealer.
D
AILY MAINTENANCE
T
(
)
RANSMISSION
GEAR
OIL LEVEL
Check level with the machine cold on a flat surface. Oil level
should be lowest of the window C(Figure 22). If needed, add
oil by this window. Drain oil from plug A(Figure 22). Use only
"SAE 90 "or "API GL-5". Oil quantity : 1.00L.
Transmission oil replacement frequency
First replacement :
After 20 hours
HST
(F
23)
OIL LEVEL
IGURE
Check HST oil level regularly with the machine on a flat surface. Be sure correct
oil level is maintained. Oil level should reach the level between "UP" and "LOW".
If needed, add oil "VG46" or "SAE10W30". Oil quantity : 0.50L.
Refill the same type of oil. Never mix different type of oil. Check for oil leak.
HST
OIL REPLACEMENT
HST oil is clean when the unit is delivered. But when the unit is used for a long
time, the inside of HST unit will be dirty because there are some sludge and the
oil is degraded. And dirty oil might disturb the smooth working.
Replace HST oil frequently for your safety and smooth working.
Also replace oil filter when HST oil is replaced.
Drain the used oil
1.
Place the suitable container below the HST unit to catch the oil, then
remove the oil drain plug (A, Figure 24).
2.
Allow the used oil to drain completely, then reinstall the oil drain plug, and
tighten the oil drain plug securely.
3.
With the HST unit on a flat surface, refill to the upper limit mark with the
recommended oil. (Refill same oil if possible.)
4.
When oil is added, please pay high attention not to mix dust with oil.
Tighten the cap securely to prevent leakage.
Never loosen the bolt (B Figure 24). Otherwise, it might influence for machine
driving. To do so is considered misuse, and damage caused by misuse is not
OREC RMK151
(F
22)
IGURE
covered by Warranty.
place
A
Later replacement:
Each 100 hours or Every year whichever comes first.
17
B
C
Figure 22
LOW
Figure 23
B
Figure 24
UP
A
Advertisement
Table of Contents
