Maintenance Operations To Be Carried Out By The User - OREC FL 500 Instruction Manual

MAINTENANCE OPERATIONS TO BE CARRIED OUT BY THE USER

BEFORE perform any maintenance operation on the machine, cut off the engine, and remove
the spark wire from the sparking plug
If maintenance operation are not realized, damages can occur to the machine and personnal injuries
to the user and/or spectators. These damages and injuries will not be covered by the warranty.
Daily maintenance will be performed by the user.

Maintenance opérations for first 20 hours, 100 et 300 should be realized by the dealer.

Ask your dealer to check the machine if you meet some problems.

Ask your distributor the name of your dealer.

DAILY MAINTENANCE BEFORE START MOWING
FUEL (FIGURE 5)
Check tank level is full before start to work. Check that tank
plug is fully closed, and check for leaks. Use only a good
quality unleaded gasoline.
Check fuel tank is closed, wipe fuel spillages before
start the machine. Check there is no fire, electric sparks,
cigarettes near the machine when refuelling.
SAFETY STICKERS
Check safety stickers are sticked at their place. Replace them if they

are worn, damage or missing.
Blade and blade holder condition
You can be cutted and injuried by cutting blade. Always wear gloves when holding blades.
Check rotary blades are in good condition, change worn or damage blade (figure 6).
Changing blade : unscrew hexagonal screws and washer from the blade holder.

Check the blade condition. Change it if it is worn bend or crackle.

Check thightening of hexagonal screws according to the chart at the end of the manual.

Sharpen as shown in C figure 6, follow the angle of 30-40°, keep a sharpen hedge of 0,4 to 0,6

mm. Always keep 30 mm of width.
•
OREC FL500A - © SAT 03/03
DANGER
DANGER
CAUTION
11
Figure 5