Table of Contents
Advertisement
F
:
UEL FILTER
Check through the filter(2, Figure 38) if there is dirt or water. Clean or change the filter if necessary.
B
:
ELT TENSION
Check belt condition. If it is worn or damaged, replace
to new one.
- If the belt is slipping, tighten the wire with the adusting
nut (B, Figure 40) until the wire spring start to be
tightened.
- If blade belt does not stop in 5 second, tighten the wire
with the adusting nut (A, Figure 40).
IMPORTANT
A bad tension belt makes sleeping and wearing
out quickly. High tension of belt will damage the
bearings.
B
:
RAKE
If brake is not working efficiently, tighten it with the nut
(B, Figure 41).
T
:
IGHTENING OF BOLTS
Check that the bolts, nuts...are properly tightened. The
vibrations tend to loosen the bolts.
A
DJUST SAFETY SWITCHES
Ajust the screws pushing the safety switches so they
push switches from 3 to 5 mm.
T
RAVEL LEVER ADJUSTMENT
Adjust the control link (A, Figure 42) in order to have the
machine motionless when the speed control lever is in
neutral.
D
IFF LOCK LEVER ADJUSTMENT
Ajust the control wire (B, Figure 42) until the lever has
a free play of 1 to 3 mm before activate the diff lock.
OREC RMK151
:
:
22
A
Figure 40
Figure 41
B
A
Figure 42
B
Advertisement
Table of Contents
