OREC RABBIT RMK151 Instruction Manual page 16

H
OW TO ADJUST HEIGHT OF OFFSET DECK
The Height of offset deck can be adjusted by changing the pin position at offset front wheel.
Standard position of the pin is in center hole (2, Figure 20).
In case of cutting in low position, change pin position to top (1, Figure 20).
In case of many stones in the fields, change pin position to lowest (3, Figure 20)
1
H
OW TO STOP THE MACHINE
Pull cutting blade lever to the top in disengage position, pull cutting height control lever to the top on travel

position.
Hold down the lever to neutral position « N ».

Turn off ignition key to stop position remove it.

Lock the parking brake, and close the fuel cock.

Avoid parking the machine in slopes, park the machine in a
flat hard and level area.
H
OW TO CARRY THE MACHINE
Use a trailer or a truck able to carry the load of the machine. When
loading the machine, use ramps able to resist to 500 kg, 30 cm wide
and equipped with unslipping surface. Check the slope is not more than 16°(Figure 21).
L :
OADING
Check cutting deck is disengage and in travel position. Lock the differantial locking.

Approach the machine of the parralel ramp adjusted to the track and locked to the truck.

Load the machine with engine at full rpm, slowly and with care.

When the machine is loaded, Turn off ignition key to stop position remove it. Lock the parking brake, and

close fuel cock. Trim the machine with straps designed according to the weight of the machine.
S
TORING THE MACHINE
Thoroughly clean the machine. Use touch up paint to prevent rust.

Check for worn and damage parts, install new parts as required

Preform the normal maintenance of the machine according to maintenance chart.

Store the machine in a dry protected area

Remove ignition key.

OREC RMK151
WARNING
2
Figure 20
16
3
Figure 21