Controls - OREC RABBIT RMK151 Instruction Manual

S
PEED CONTROL LEVER
This lever is used to go forward, reverse and stop the
machine (1, Figure 5). When the lever is moved
rearward to « R » the machine is going on reverse.
When lever is moved from « N » to « F » the machine is
going forward. When lever is located in « N » position
the machine is stopped.
Travel speed is increased by push the lever from « N »
to « F » or « R ». Travel speed is decreased by push the
lever from « F » or « R » to « N ».
Push or release lever gradually (except on an
emergency) in order to avoid sudden stop and go.
When you release the speed lever to stop, it brake
the machine. Release the lever to « N » gently,
except in case of emergency to avoid sudden
T
HROTTLE LEVER
Push the throttle lever(2, Figure 5) forward to increase engine speed, pull the throttle lever rearward to decrease
engine speed to idle rpm. Always operate mower at full engine speed.
D
IFFERENTIAL LOCKING LEVER
This lever(3, Figure 5) allows the rear wheels to be driven together in slipping areas. (Figure 5). Apply the diff lock
lever when one wheel is slipping in straight line. Release the lever as soon as the machine leaves the slipping
area.
The diff lock shoud be used in straight line only : never use the diff lock lever when turning. The
damage to the transmission will not be covered by the warranty
H
EIGHT OF CUT CONTROL LEVER
The highest position of the lever (1, Figure 6)
match to the transport position.
You can adjust the cutting height freely by
pressing the push button (2) and the lever (1).
When the lever position is high, the height of cut
is high, when lever position is low, the height of
cut is low.
When cutting height is in low position, the machine needs stronger power, and spread more thrown
objects. Cutting low can cause damage to the machine and injury.
BLADE CLUTCH LEVER
The cutting blade Clutch lever make the engine drive the blade to mow. (3, Figure 6). Push the lever forward make
the blade turning. Pull the lever on reverse to stop the blade.
When using blade clutch lever, check that height of cut lever is in mowing position.
OREC RMK151

CONTROLS

(HST)
DANGER
stops.
3
1
2
WARNING
9
Figure 5
1
Figure 6
2
3