OREC RABBIT RMK151 Instruction Manual page 19

S
IDE GUARDS AND SHIELDS
Check lateral guards and shields are bolted.
E
LECTROLYTE BATTERY LEVEL
Check electrolyte level is between the upper and lower
level. Add distilled water as requiered.
Be carefull when maintening the battery. Avoid flames,
and sparks. Always wear gloves and glasses. Wash
with water if you are hit by electrolyte.
F L (F 29)
RONT IGHT IGURE
Switch on the front light on the dash board.
B
LADE AND BLADE HOLDER CONDITION
Check that rotary blades are in good condition, change worn or
damaged parts.
How to replace blade :
1 – Remove the blade by loosening the hard lock nut. Remove the
upper nut, and then remove the lower nut.
2 - After changing to new Blade(or to reversed blade)
It also should be changed to new Blade Bolt, Hard Lock Nut and Nut
Guard as shown in Figure 30.
The cutting blade can cut user's hand. You can be cut and injuried
by cutting blade. Always wear gloves when holding blades.
Use only the OREC original parts : " non genuine " parts will not assure you of
a correct and safe working and are likely to make the warranty null and void.
Check also the Knife Stay for wear. Even if you do not see any bend or any

abrasion on Knife Stay, you should replace it at every 100 hours or every 2 years
of use.
Please check Blade frequently because it abrades early when you work at a place

including dry soil or sand.
We recommend that you purchase spare Blade and spare Blade Set Bolt in

advance and keep them at your hand.
When the Blade Set Bolt is worn on its head(1, Figure 31), it can cause serious

accident with the blade thrown away. Replace the Blade Set Bolt immediately
when the dent disappeared. Also, Replace(or reverse) the blade when it is worn
up to 30% (Figure 31).
OREC RMK151
(F 28)
IGURE
DANGER
CAUTION
CAUTION
Upper
Level
Lower
Level
Hard Lock Nut
Nut guard
Knife
Stay
Blade
Blade set bolt
19
Battery
Figure 28
Figure 29
Knife collar
Figure 30
30%
30%
Figure 31
Upper
Nut
Lower
Nut