OREC RABBIT RMK151 Instruction Manual page 12

M
OWING DECK SIDE SHIELDS
The mowing deck side shields should be unlocked to allow the machine to be loaded on a truck or a trailer. This
shields should be locked for mowing.
The mowing deck side shields should be locked by bolt and nuts when mowing with the machine.
Check if the guards and shields are locked by bolt and nuts before mowing. If they are not locked,
E
NGINE
The mower is delivered with the engine owner's manual. Read the engine manual before using the machine.
H
OW TO LIFT UP AND DOWN THE OFFSET DECK
H
OW TO LIFT UP THE OFFSET DECK
Shift the height of cut lever to transport position.

Then grip front tire BK on the offset deck and lift it up and the hanger lever shift it in.

Figure 11
Make sure that machine is on flat place and get out of the machine before to lift up the hanger lever. It
might cause operator's back problem or tipping over if lifting up the hanger lever from seating position.
Never engage the blade when the hanger lever is lifted up while driving.
It is very dangerous because the blade might be rotating with the offset deck open.
And never engage the blade when lifting up offset deck because it cause belt dropping or belt cutting.
Never mow only using the center blade the offset hanger lever is lifted up.
H
OW TO SHIFT DOWN THE OFFSET DECK
Make sure that height of cut lever is in transport position.

Then grip the hanger lever and the front tire BK.

Shift the hanger lever out, then the lock is released and the offset deck will reach the ground.

To avoid falling the offset deck suddenly, shift it out slowly gripping the front tire BK.

S
AFETY SWITCHES
The OREC mower is equipped with safety switches :
To start engine when cutting blade lever is disengage, if you do not press the brake pedal, you cannot start

engine.
When the engine is running, the operator leave the seat, the engine is cut off.

OREC RMK151
DANGER
thrown object will cause injury and damage.
.
CAUTION
WARNING
12
Figure 12