OREC RABBIT RMK151 Instruction Manual page 11

Grassland mower
Table of Contents

Advertisement

Always remove the key when machine is not used. When the engine is stopped, check than the key is
on "stop" position. Do not engage the electric starting motor more than 10 seconds.If the engine has
not start after 10 seconds, wait for 30 seconds before engage the electric starting motor again.
B
RAKE PEDAL
The brake pedal(3, Figure 8) is used in case of emergency or when the parking brake is locked. When brake
pedal is pressed, travel speed lever is automatically moved to neutral position « N ».
To lock parking brake, press the brake pedal, then turn the locking lever(4, Figure 8) to the right. Press and release
the pedal to unlock the parking brake.
Use the brake pedal in case of emergency only or to lock parking brake. If brake pedal is used at high
Do not let the machine in the slopes, do not move the travel lever when the parking brake is locked, this
will damage the transmission. When leaving the machine be sure that the parking brake is locked,
cutting blades are in off position and ignition key is removed.
OFFSET OPEN/CLOSE PEDAL
Press this pedal(5, Figure 8) to close the offset deck, and release the pedal to open the offset deck. Use the lock
lever(6, Figure 8) to fix the offset deck in closed position. Push the pedal(5, Figure 8) to release the lock lever.
CHANGE PEDAL
Push the change pedal (7, Figure 8) forward to drive forward, and push it rearward to drive rearward.
Depending on the angle of pedal, speed is controlled. When this pedal is not pressed, speed comes back to
neutral position. The change pedal is linked with speed control lever (1, Figure 5).
S
EAT
Pull up the adjust lever(1, Fig 9) and slide the seat to change the seat position. Release the lever, then seat
position is locked.
It is possible to adjust the strength of the spring according to the weight of the user. If the suspention adjusting
bolt(2, Figure 9 & 10) is turned clockwise, the spring is tensioned. If the suspention adjusting bolt is turned
unclockwise, the spring is loosened.
1
OREC RMK151
speed, the machine will stop suddenly.
(Seat)
Figure 9
CAUTION
WARNING
WARNING
2
11
(view from top)
Figure 10

Advertisement

Table of Contents
loading

Table of Contents