Installing The System Into A Rack - Supero SuperServer 6024H-32 User Manual

S S
UPER ERVER 6024H-32R/6024H-32 User's Manual
2-4

Installing the System into a Rack

This section provides information on installing the SuperServer 6024H-32R/6024H-
32 into a rack unit. If the 6024H-32R/6024H-32 has already been mounted into
a rack, you can skip ahead to Sections 2-5 and 2-6. There are a variety of rack
units on the market, which may mean the assembly procedure will differ slightly.
The following is a guideline for installing the system into a rack with the rack rails
provided. You should also refer to the installation instructions that came with the
rack unit you are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the SuperServer 6024H-
32R/6024H-32. Each of these assemblies consist of two sections: an inner fi xed
chassis rail that secures directly to the 6024H-32R/6024H-32 (A) and an outer
fi xed rack rail that secures directly to the rack itself (B). All screws and hardware
mentioned in the installation steps should be included in the hardware kit.
To remove the fi xed chassis rail (A), pull it out as far as possible - you should hear
a "click" sound as a locking tab emerges from inside the rail assembly and locks
the inner rail. Then depress the locking tab to pull the inner rail completely out.
Do this for both the left and right side rack rail assemblies.
Figure 2-1. Identifying the Sections of the Rack Rails
Locking Tab
A
2-4
B