Drive Bay Installation/Removal - Supero SuperServer 6024H-32 User Manual

S S
UPER ERVER 6024H-32R/6024H-32 User's Manual
Cover Release Buttons
Motherboard
6-4

Drive Bay Installation/Removal

Accessing the Drive Bays
SAS/SATA Drives: You do not need to access the inside of the chassis or remove
power to replace or swap SAS/SATA drives. Proceed to the next step for instruc-
tions. Note: You must use standard 1" high, SAS/SATA drives in the SuperServer
6024H-32R/6024H-32.
CD-ROM/Floppy Disk Drive: For installing/removing the CD-ROM or fl oppy disk
drive, you will need to gain access to the inside of the server by removing the top
cover of the chassis. Proceed to the "CD-ROM and Floppy Drive Installation" sec-
tion later in this chapter for instructions.
5.25" Drive Bay: For installing/removing a component in the 5.25" drive bay, proceed
to the "5.25" Drive Bay Installation" section later in this chapter for instructions.
Figure 6-2. System Cooling Fans
Chassis Cover (removed)
System Cooling Fans
6-4
System Memory
Power Supply