Notch
Release
Tab
To Install: Insert module vertically and press down until it snaps into place. Pay attention to the bottom
notches.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from the
slot.
5-7
Adding PCI Add-On Cards
The 6024H-32R and 6024H-32 can accommodate all PCI expansion slots on the
X6DH3-G2 being populated with low-profi le cards.
To install an add-on card, begin by removing the PCI slot shield for the slot you
wish to populate. Fully seat the card into the card slot on the serverboard, push-
ing down with your thumbs evenly on both sides of the card. Finish by using a
screw to secure the top of the card shield to the backpanel of the chassis. The
PCI slot shields protect the serverboard and its components from EMI and aid in
proper ventilation, so make sure there is always a shield covering each unused
PCI-E/PCI-X/PCI slot.
Chapter 5: Advanced Serverboard Setup
Figure 5-4. DIMM Installation
Note: Notches
should align
with their
receptive points
on the slot
5-9
Notch
Release
Tab