Table of Contents
Advertisement
S
S
UPER
ERVER 6024H-32R/6024H-32 User's Manual
Unpacking
The serverboard is shipped in antistatic packaging to avoid electrical static dis-
charge. When unpacking the board, make sure the person handling it is static
protected.
5-2
Serverboard Installation
This section explains the fi rst step of physically mounting the X6DH3-G2 into the
SC823T-R500LP/SC823T-550LP chassis. Following the steps in the order given
will eliminate the most common problems encountered in such an installation. To
remove the serverboard, follow the procedure in reverse order.
1. Accessing the inside of the system
Remove the screws from the back lip of the top cover of the chassis, then pull the
cover off.
2. Check compatibility of serverboard ports and I/O shield
The X6DH3-G2 requires a chassis big enough to support a 12" x 13.05" mother-
board, such as Supermicro's SC823T-R500LP/SC823T-550LP. Make sure that the
I/O ports on the serverboard align properly with their respective holes in the I/O
shield at the back of the chassis.
3. Mounting the serverboard onto the serverboard tray
Carefully mount the serverboard to the serverboard tray by aligning the board holes
with the raised metal standoffs that are visible in the chassis. Insert screws into all
the mounting holes on your serverboard that line up with the standoffs and tighten
until snug (if you screw them in too tight, you might strip the threads). Metal screws
provide an electrical contact to the serverboard ground to provide a continuous
ground for the system. Finish by replacing the top cover of the chassis.
5-2
Advertisement
Table of Contents
