Table of Contents
Advertisement
Appendix B: Software Installation
Rebuilding Arrays
Note: Rebuilding applies to Fault Tolerant arrays (RAID 1) only.
If an array Build process (or initialization) is interrupted or critical with one member
missing, you must perform a Rebuild to get the array to optimal status. For a critical
array Rebuild operation, the optimal drive is the source drive.
Note: If no spare array exists and a hard disk drive fails, you need to create a spare
before you can rebuild an array.
To Rebuild an array:
1. From the Main Menu, select Manage Arrays (as shown in the screen below).
From the List of Arrays, select the array you want to rebuild.
2. Press Ctrl+R to rebuild.
B-15
Advertisement
Table of Contents
