Accessing The Drive Bays - Supermicro SUPERSERVER 6013P-8 Plus User Manual

Supermicro superserver 6013p-8 plus servers: user guide
Table of Contents

Advertisement

Figure 6-3. Removing the Front Bezel

Accessing the Drive Bays

SCSI Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace SCSI drives.
Proceed to the next step for instructions.
CD-ROM/Floppy Disk Drives: For installing/removing a CD-ROM or floppy disk
drive, you will need to gain access to the inside of the 6013P-8+ by removing the
top cover of the chassis. Proceed to the "CD-ROM and Floppy Drive Installation"
section later in this chapter for instructions.
Note: Only a "slim" CD-ROM drive will fit into the 6013P-8+.
Chapter 6: Advanced Chassis Setup
1. Unlock
2. Press release knob
3. Remove bezel assembly
6-5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SUPERSERVER 6013P-8 Plus and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents