User's Manual of ICA-3480/ICA-4480/ICA-3480F/ICA-4480F/ICA-M3580P/ICA-M4580P
8.4 Video
In the main interface, click "Config Video" to enter the video and audio configuration interface,
where you can set the device video, audio and other functions.
8.4.1 Video
In the main interface click "Config Video Video" into the video configuration interface,
where you can set the IP Camera device name, stream type, encoding and other video
parameters, as shown in Figure 8-9:
【Stream Type】Default is the Main Stream, you can select Sub Stream.
【Profile】Default is the Main Profile; you can select Baseline Profile or High Profile.
【Video Encoding】Switch the encoding method in the drop-down menu.
【Resolution】Switch the output resolution in the drop-down menu.
【Framerate】Set the frame rate of the current output video of the device.
【Bit Rate】Supports 64-12000kbps. The higher the bit rate goes, the better the video quality
will be, but it occupies the greater network bandwidth and the greater the pressure
transmission.
【Rate Control】 Switch the code rate output mode in the drop-down menu, fixed rate and
variable rate.
【I-Frame Interval】IP Camera acquisition key frame interval.
【H265+/H264+】Turn on/off the camera H265+/H264+.
Different IP Camera -- device stream type, encoding, frame rate and other information in the
drop-down menu options are also different.
Only cameras that support the H264/H264+ function display Profile items on the video interface.
When the frame rate is set too low, it will cause video lag. Please be careful.
The higher the bit rate is, the greater the current network bandwidth and the greater the
transmission pressure will be.
Only cameras that support the H264+/H265+ function displaying H264+/H265+ on/off items on
the video interface.
It takes 30-60 seconds for the camera to turn the H265+/H264+ on or off. Please be patient.
Figure 8-9
50