Smart Event - Planet ICA-3480 User Manual

User's Manual of ICA-3480/ICA-4480/ICA-3480F/ICA-4480F/ICA-M3580P/ICA-M4580P

8.6.2 Smart Event

① Intrusion Detection
The area intrusion detection is used to detect whether a person enters the set area in the video
setting area, and the alarm is linked according to the judgment result.
The specific operation steps are as follows:
Step 1: In the main interface click on the "Configuration  Events  Smart Event  Intrusion
Detection" to enter the Intrusion Detection settings interface, as shown in Figure 8-30.
Figure 8-30
Step 2: Check "Enable" to enable intrusion detection.
Step 3: Select "Warning Area": The system supports setting up to 4 warn regions. After
selecting a warn region, you need to make the following settings. After setting, please click
"Apply" below.
【Drawing Area】Click "Drawing Area" and move the mouse to the preview screen. Click the
left mouse button and draw the endpoint of the quadrilateral guard area, and then click the
preview interface to complete the area drawing.
【Clear All】Used to delete the selected alert area.
【Time threshold(s)】Indicates that the target enters the alert zone and continues to stay for
this time to generate an alarm. If set to 5s, the target intrusion area will trigger an alarm after 5s.
【Sensitivity】Used to set the sensitivity of detected area intrusion. The default is 50. Drag the
progress bar or enter the value directly in the value box to modify the sensitivity. The greater the
sensitivity is, the easier it is to trigger an alarm.
Step 4: When you need to set other Warning Area, repeat step 3 to complete the setup.
68