Network; Basic Setup - Planet ICA-3480 User Manual

User's Manual of ICA-3480/ICA-4480/ICA-3480F/ICA-4480F/ICA-M3580P/ICA-M4580P

8.3 Network

In the main interface, click "Config  Network" to enter the network settings interface, the
network is divided into Basic Config, P2P and Email configuration.

8.3.1 Basic Setup

① TCP/IP
The TCP/IP interface is used to view and configure network parameters such as the camera's
IP address. You can enable DHCP or manually modify to configure the IPC network
parameters.
Enable DHCP:
Connect IPC to the router with DHCP enabled, and then IPC will obtain the corresponding IP
address, subnet mask, default gateway, and preferred DNS server information.
The specific steps for manually modifying network parameters are as follows:
Step 1: In the main interface, click "Config  Network  Basic Setup  TCP/IP" to enter the
TCP/IP interface, as shown in Figure 8-6 ①.
Figure 8-6 ①
Step 2: Set the IP address (IPv4 or IPv6 format), subnet mask, gateway, and DNS.
Step 3: Click "Test" to make sure the modified IP address is available in the LAN.
Step 4: Click "Apply" to save the configuration.
38