Using The Administrator Settings - Sharp MX-M350U Operation Manual

USING THE ADMINISTRATOR SETTINGS

The procedure for configuring the administrator password is explained below using the "Change admin password" as
an example. Follow the same steps to configure the settings that are described beginning on page 7.
1 Press the [SYSTEM SETTINGS] key.
PY
SYSTEM
JOB STATUS SETTINGS
2 Touch the [ADMINISTRATOR SETTINGS]
key.
FAX DATA
SENDER CONTROL
RECEIVE/FORWARD
ADMINISTRATOR SETTINGS
Use the numeric keys to enter the 5-digit
3
administrator password.
ADMINISTRATOR PASSWORD
Touch the [CHANGE ADMIN PASSWORD]
4
key .
PRINTER
NGS
SETTINGS
CHANGE ADMIN
PASSWORD
Configure the setting as explained on pages 7 and
following of this manual.
4
Each time a number is
entered, the dashes (-)
in the display will change
to asterisks ( ). The
factory default setting for
the key operator code
number is 00000.
If you wish to configure a
different administrator
setting, select the
desired setting in this
step.
A screen for the selected
setting will appear.
5 Use the numeric keys to enter the new
5-digit administrator password.
-----
00000
number cannot be used). The entered number will
be the new administrator password. Be sure to
remember this number.
6 Touch the [OK] key. You will return to the
screen of step 4.
OK
Touch the [EXIT] key.
7
EXIT
OPERATION
SETTINGS 1/2
PRINTER
Use a number for the
administrator password
that has not been set as
an account number for
auditing mode (a
number that has been
set as an account
This completes the
procedure for changing
the administrator
password. If you wish to
configure another
setting, touch the key of
the desired setting in the
screen of step 4.
You will exit the
administrator settings.