Programming And Editing Paper Types - Sharp MX-M350U Operation Manual

Programming and editing paper types

To program or edit the name of a paper type or set paper attributes, follow the steps below.
1 Follow steps 1 and 2 of "Setting the paper
type and paper size" (page 2-5)
2 Touch the [PAPER TYPE REGISTRATION]
key.
OK
PAPER TYPE REGISTRATION
Select the paper type that you wish to
3
program or edit.
SYSTEM SETTINGS
TRAY 2 TYPE/SIZE SETTING
SELECT THE PAPER TYPE
USER TYPE 1 USER TYPE 2 USER
USER TYPE 5
USER TYPE 6 USER
Touch the [TYPE NAME] key.
4
PAPER TYPE REGISTRATION
No.01
TYPE NAME USER TYPE 1
DISAB
FIXED PAPER SIDE
DISAB
DISABLE STAPLE
5 Set the attributes of the paper tray.
PAPER TYPE REGISTRATION
No.01
TYPE NAME USER TYPE 1
DISAB
FIXED PAPER SIDE
DISABLE STAPLE DISAB
A character entry screen
appears.
Enter a type name
(maximum of 14
characters). (See page
7-29 to enter characters.)
Touch the checkboxes to
the left of the items to
select them.
"FIXED PAPER SIDE" : Select when paper is to be
loaded print side down in the
tray. Make sure a checkmark
does not appear when paper is
to be loaded print side up.
• If the two-sided function is
prohibited in "DISABLING OF
DUPLEX" in the administrator
settings
administrator settings guide), do
not use this setting.
"DISABLE DUPLEX" : Prohibits two-sided printing.
Enable when the back side of
the paper cannot be printed
on.
"DISABLE STAPLE" : Prohibits
when using special papers
such as transparency film and
label sheets.
"DISABLE PUNCH" : Prohibits
when using special papers
such as transparency film and
label sheets.
NOTE
"FIXED PAPER SIDE" and "DISABLE DUPLEX"
cannot be simultaneously enabled.
Touch the [EXIT]
6
programming/editing procedure.
CANCEL EXIT
DISABLE DUPLEX
DISABLE PUNCH
LOADING PAPER
(page 11 of the
stapling. Enable
punching. Enable
key to exit the
2-7
2