Storing, Using And Deleting Job Programs; Storing A Job Program - Sharp MX-M350U Operation Manual

STORING, USING AND DELETING
JOB PROGRAMS
The steps of up to 10 copy jobs can be stored as job programs. Job programs can be called up with ease, and are
retained even when the power is turned off. By storing frequently used copy settings in a job program, you can
eliminate the bother of selecting the settings each time you use them for a copy job.
●If any settings related to the steps of a job program are changed in the administrator settings after the job program
is stored, the steps related to the changed settings will not be included when the job program is called up.
●To exit the job programs mode, press the [CA] (clear all) key on the operation panel or touch the [EXIT] key on the
touch panel.

Storing a job program

Press the [#/P] key.
1
LOGOUT
Touch the [STORE/DELETE] key.
2
M NUMBER.
RECALL STORE/DELETE
3 Touch the number key ([1] to [10]) in which
you wish to store the job program.
PROGRAMS
ESS PROGRAM NUMBER.
RECALL STORE/
4 Select the copy settings that you wish to
store in the job program.
TO STORE, MAKE SELECTIONS AND PRESS
[OK], TO DELETE, PRESS [CANCEL].
SPECIAL MODES
2-SIDED COPY
OUTPUT
8 x11 1 /
2
8 x11 1 /
2
8 x14 1 /
2
11x7
5-42
Number keys in which
job programs are
already stored are
highlighted.
The number of copies
cannot be stored.
Touch the [OK] key.
5
NCEL OK
AUTO
ORIGINAL
AUTO
■ If a number key is selected in step 3 that has
already been programmed.
A setting confirmation screen will appear. To replace
the existing program with the new program, touch
the [STORE] key and continue from step 4. If you do
not wish to replace the existing program, touch the
[CANCEL] key to return to the screen of step 3 and
select a different number key.
NOTE
If overwriting of programmed copy settings has been
prohibited in the administrator settings, it will not be
possible to store or delete a job program. (See page
17 of the administrator settings guide.)
The selected settings
will be stored in the
number key selected in
step 3.