Calling Up A Job Program; Deleting A Stored Job Program - Sharp MX-M350U Operation Manual

Calling up a job program

1 Press the [#/P] key.
LOGOUT
Touch the number key of the desired job
2
program.
JOB PROGRAMS
PRESS PROGRAM NUMBER.
RECALL

Deleting a stored job program

1 Press the [#/P] key.
LOGOUT
2 Touch the [STORE/DELETE] key.
M NUMBER.
RECALL STORE/DELETE
Select a storage register number of the
3
program to be deleted.
EXIT
STORE/DELETE
The screen
automatically closes and
the job program is called
up. A number key that
does not have a job
program cannot be
selected.
If a number key for which
no job program has been
stored is selected, the
screen will change to the
screen of step 4 on the
previous page for storing
a job program.
STORING, USING AND DELETING JOB PROGRAMS
3 Set the number of copies if needed and
then press the [START] key.
4 Touch the [DELETE] key.
A JOB PROGRAM HAS BEEN ALREADY STORED
IN THIS LOCATION.
CANCEL DELETE STORE
RECALL STORE/DELETE
[EXIT] key displayed in the screen of step 3 to exit
the job program mode.
NOTE
If overwriting of programmed copy settings has been
prohibited in the administrator settings, it will not be
possible to store or delete a job program. (See page
17 of the administrator settings guide.)
Copying will begin using
the settings of the job
program.
The selected program is
deleted and you return
to the screen of step 3.
To return to the screen of
step 3 without deleting
the job program, touch
the [CANCEL] key. In
both cases, touch the
5-43
5