Configuration; Configuration Options - ABB Endura ACA592-TC Operating Instructions Manual

Endura ACA592
Toroidal conductivity transmitter

6 Configuration

6.1 Configuration Options

ACA592 toroidal conductivity transmitter configuration options comprise:

Configuration via the transmitter's navigation keys.
Note.

Complete configuration of the transmitter is available through the HMI. However, not all
transmitter DTM functions (for example, such as Diagnosis Masking) are accessible via the
transmitter's navigation keys.

Communication with the transmitter is supported by the HART protocol – refer to Section
9, page 72 for HART commands.

Configuration via FDT/DTM technology.
Configuration can be performed with any FDT network applications that are approved for use with
the DTM (for example, ABB AssetVision Basic / Professional). The bus can be connected via FSK
modem as well as HART + USB or HART Multiplexer.

Configuration via EDD technology.
Configuration can also be performed with EDD master applications such as Siemens Simatic PDM,
that is approved for use with EDD.

Configuration using a handheld terminal.
ACA592 Transmitter
Fig. 6.1 Configuration Options – Schematic
44
Modem
Handheld
Device
ABB Asset Vision
or DCS Config
FTD/DTM or EDD
Technology
OI/ACA592/TC–EN Rev. B
6 Configuration