Table of Contents
Advertisement
Endura ACA592
Toroidal conductivity transmitter
3.4.6 Aligning the Cartridge LCD Display
Warning. Isolate the transmitter from power supplies before aligning the cartridge LCD display.
Because the transmitter's mounting bracket enables the transmitter housing to be positioned in 90 ° steps
only between 0 and 360 °, it may be necessary to re-position the cartridge to ensure the cartridge LCD
display is readable when mounted.
A
Fig. 3.10 LCD Display Alignment
To align the display:
1. Unscrew the cartridge cover
2. Depress the 4 locking lugs on the side of the cartridge
3. Pull the cartridge
the 6-pin connector
4. Align one of the 4 plug positions
ensure the cartridge LCD display is readable when mounted.
5. Refit the cartridge
C
the cartridge
6. Refit the cartridge cover
B
.
OI/ACA592/TC–EN Rev. B
C
A
and remove it from the transmitter
C
carefully but firmly out of the transmitter
D
.
E
on the rear of the cartridge
C
in the new position by pushing it carefully but firmly into the transmitter. Keep
straight to avoid bending the 6-pin connector
A
by screwing it until the O-ring is slightly compressed onto the transmitter
B
D
B
C
one at a time.
B
keeping it straight to avoid bending
C
D
.
3 Mechanical Installation
E
.
with the 6-pin connector
D
to
25
Advertisement
Table of Contents
