Table of Contents
Advertisement
Endura ACA592
Toroidal conductivity transmitter
1.8 Returning Transmitters
Use the original packaging or suitably secure packaging for returning the transmitter for repair or
recalibration. Contact the local ABB office or sales representative for return authorization number and
address.
All transmitters returned for service or repair to ABB must be free from any hazardous materials (acids,
alkali, solvents, etc.).
1.8.1 Transport Safety Information
Observe the following information:
Do not expose the transmitter to moisture during transport. Pack the transmitter accordingly.
Pack the transmitter so that it is protected from vibration during transport, e.g. through air-cushioned
packaging.
Check the transmitter for possible damage that may have occurred from improper transport. Damages in
transit must be recorded on the transport documents. All claims for damages must be claimed against the
shipper and before the installation.
1.9 Restriction of Hazardous Substances (RoHS)
The European Union RoHS Directive and subsequent regulations introduced in member
states and other countries limits the use of six hazardous substances used in the
manufacturing of electrical and electronic equipment. Currently, monitoring and control
RoHS
instruments do not fall within the scope of the RoHS Directive, however ABB has taken
the decision to adopt the recommendations in the Directive as the target for all future
product design and component purchasing.
1.10 Safety Precautions
Please read the entire manual before unpacking, setting up, or operating this instrument.
Pay particular attention to all warning and caution statements. Failure to do so could result in serious injury
to the operator or damage to the equipment.
To ensure the protection provided by this equipment is not impaired, do not use or install this equipment in
any manner other than that which is specified in this manual.
OI/ACA592/TC–EN Rev. B
1 Safety
9
Advertisement
Table of Contents
