Aca592 Toroidal Conductivity Transmitter - Sensor Connections - ABB Endura ACA592-TC Operating Instructions Manual

Endura ACA592
Toroidal conductivity transmitter
4.3.1 ACA592 Toroidal Conductivity Transmitter – Sensor Connections
To connect the sensor:
1. Refer to Table 4.2 to identify the correct cable wires for the ACA592–TC toroidal conductivity
transmitter.
2. Route the sensor wiring through one of the three threaded connections and use an appropriate
gland in the transmitter housing (refer to Fig. 4.1, page 27 for cable gland options). Note, use of the
cable gland is required.
3. Loosen the sensor connection terminal captive screws using a a flat-bladed screwdriver (3.5 / 4 mm
or Size-1).
4. Insert each sensor cable wire under the open terminals and secure by tightening the terminal captive
screws.
10
Fig. 4.3 ACA592–TC Toroidal Conductivity Transmitter – Sensor Connections at Transmitter Terminals
Connection Information
Transmitter Terminal
4
5
6
7
8
9
10
11
Table 4.2 ACA592–TC Toroidal Conductivity Transmitter – Compatible Sensor Cable Colors
30
Key:
4
Drive
5
Drive
6
Sense
7
Sense
Function
Drive
Drive
Sense
Sense
RTD 1
RTD 2
Shield
RTD 3
4 Electrical Installation
Connection Label
(inside End Cap)
8
RTD 1
9
RTD 2
0
Shield
k
RTD 3
Sensor Cable Color
TB4
Black
Blue
White
Red
Green
Yellow
Dark Green
None
OI/ACA592/TC–EN Rev. B