Sensor Connections - ABB Endura ACA592-TC Operating Instructions Manual

Endura ACA592
Toroidal conductivity transmitter

4.3 Sensor Connections

Caution.

The connection terminals accept cables up to a maximum peripheral wire cross section of
2
2.5 mm (12 SWG [10 AWG]).

Do not use a rigid conductor material as this can result in wire breaks.

Ensure the connecting cable is flexible.

To ensure the sensor cable length is sufficient, allow an additional 100 mm (4 in.) of cable to pass
through cable glands and into the housing.

Ensure the correct connections are made to suit the transmitter variant – ACA592–TC (see
Section 4.3.1, page 30).
OI/ACA592/TC–EN Rev. B
4 Electrical Installation
29