ABB Endura ACA592-TC Operating Instructions Manual page 58

Endura ACA592
Toroidal conductivity transmitter
Device Setup Level
Parameter
Temp. Sensor
Temp. unit
Temp. Comp. Type
Manual Temp
Auto TC Option
TC Coeff
User Def. TC Curve
Reference Temp
Temp. Sensor Type
Run TC Recognition
TC Recognition Stat
56
Description
Temperature sensor parameters.
Sets the temperature unit (°C or °F) applied to all transmitter temperature parameters and
values.
Temperature compensation type.

Manual
Manual temperature compensation is enabled when the device does not detect any
temperature sensor connection either at power-up or upon execution of Run TC
Recognition. When Temp Comp Type is Manual, the user configurable Manual Temp
value is used for temperature compensation.

Auto
Enabled when a temperature sensor is detected by the device either at power-up or
when executing the Run TC Recognition (see page 56) routine.
Enabled when Temp Comp Type = Manual.
The value in this parameter is used for temperature compensation during Manual
temperature compensation mode.
Adjustable range –20 to 150 °C (–4 to 302 °F). Default = 25 °C (77 °F).
Enabled when Temp. Comp Type = Auto (temperature sensor input is detected).
Options comprise:

Standard KCl

TC Coeff

User Def.

NaOH

NaCl

HCl

H SO
2 4
Enabled when a temperature sensor is detected and Auto TC Option = TC Coeff.
Enabled when a temperature sensor is detected and Auto TC Option = User Def. TC.
Enables entry of user-defined temperature compensation curve.
Range = Temp 1 to Temp 6, K1/Kref to K6Kref.
Sets the required reference temperature.
Indicates the type of temperature sensor detected.
Options comprise:

Pt100

Pt1000
Starts the auto recognition process for the sensor.
Indicates if the temperature sensor was recognized / not recognized, either during startup or
after execution of the Run TC Recognition function.
7 Operator Pages and Menus
OI/ACA592/TC–EN Rev. B