Integral Sensor Cable Connection; Junction Box And Extension Cable Connection - ABB Endura ACA592-TC Operating Instructions Manual

Endura ACA592
Toroidal conductivity transmitter 4 Electrical Installation

4.4 Integral Sensor Cable Connection

For installations where the sensor is close to the transmitter, use an integral c cable. This design is preferred
for submersible installations as there is no connector that could be affected by moisture.
For ease of sensor replacement, keep the cable length to a minimum.
Fig. 4.4 Sensor with Integral Cable

4.5 Junction Box and Extension Cable Connection

For some applications, an extension cable is available that can be installed permanently between the
sensor and the transmitter. The sensor has a junction box mounted either directly on it or in close proximity.
The extension cable is connected to the sensor inside the junction box.
Cable with
Tinned Connectors
Sensor
Fig. 4.5 Sensor with Junction Box and Extension Cable
OI/ACA592/TC–EN Rev. B 31