Carlton SP7015 TRX Owner's Manual page 72

 Bolt grease fitting to the air filter
bracket.
 Before starting the engine, apply grease
to the grease fitting until the pin on the
opposite side of the stub shaft pops out.
This must be done daily to protect the
bearing in the stub shaft assembly.
 Start replacing parts in the opposite
order in which they were removed.
Replace the V-belt guard and then
replace the engine and jackshaft sheaves.
Torque the bolts in the sheaves to 30 ft.
lbs. It will be easier to bolt the belt
keepers onto the stub shaft plate before
you put the engine sheave on.
 Replace the V-belt and align the sheaves
as instructed in the Servicing Belt
Section of this manual. Adjust sheaves
as necessary to get the proper belt
alignment. Check belt tension and set as
described in Servicing Belt section. Belt
alignment and tension are very important
for long bearing life. Always replace
belt guard cover before running the
machine.
 Grease stub shaft bearing through the
end of the shaft. Apply 2 to 3 shots of
grease approximately every 1000 hours
of operation. Wipe off excess grease.
Excess grease will attract dirt. DO
NOT over grease, over greasing could
cause a hydraulic type lift on seals.
SP7015 TRX SERVICING STUB SHAFT
52