Carlton SP7015 TRX Owner's Manual page 55

Replacing Poly Chain
SAFETY
 NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
 CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
 ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
 DO NOT OPERATE A MACHINE WITHOUT A COMPLETE SET OF TEETH
PROPERLY INSTALLED. EXCESSIVE MACHINE VIBRATION WILL OCCUR
CAUSING PREMATURE BEARING FAILURE AND OTHER EQUIPMENT
DAMAGE.
 PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
Special care needs to be taken with your Poly Chain
of this belt are very important. The Poly Chain
approximately every 70 to 100 hours of use. The Poly Chain
adjust one bearing more than the other, the belt will run on an angle, which will cause belt
failure. A belt broken straight across is the result of a shock load. In a shock load failure, the
fibers are broken and over a period of time the belt will break down from the shock load and
snap in half. A broken belt with lost teeth indicates that the belt was loose. When replacing the
Poly Chain belt, do not try to pry belt on over pulley this can break the fibers. After you have
®
installed or re-tensioned the Poly Chain
proper tension.
 Remove the Poly Chain
and bottom cover.
SP7015 TRX
Belt
®
belt, you will have to re-adjust the engine belt for
®
guard cover
®
SERVICING BELTS
belt. Alignment, tension, and cleanliness
®
belt needs to be checked for tension
®
belt must be running true. If you
®
35