Carlton SP7015 TRX Owner's Manual page 62

OPTIONAL:
Razor Cutter Wheel
 If the machine is supplied with the
optional Razor cutter wheel, there are
forty-eight (48) teeth to a complete set.
There are sixteen (16) Short Plow Bolt
Bits and thirty-two (32) Plow Bolt Bits.
 DO NOT OPERATE A MACHINE
WITHOUT A COMPLETE
NUMBER OF TEETH IN THE
CUTTER WHEEL PROPERLY
INSTALLED. EXCESSIVE
MACHINE VIBRATION WILL
OCCUR CAUSING PREMATURE
BEARING FAILURE AND
EQUIPMENT DAMAGE.
 A locking pin is provided to hold cutter
wheel in position during tooth removal
and re-installation.
 The locking pin will only lock in the
deep slots of the outer teeth. Line the
slot up with the locking pin slot and
insert the pin to lock position. The pin
will need to be removed and reinserted
as wheel is rotated to change remaining
teeth.

NEVER PLACE YOUR HAND ON
THE CUTTER WHEEL TO HOLD IT
IN PLACE WHILE CHANGING
TEETH.

BE SURE TO REMOVE THE PIN
BEFORE OPERATING THE STUMP
CUTTER.
 The teeth do not require a setting gauge.
The only requirement is to be installed in
the proper direction and tightened to the
proper torque as discussed in the next
section.
 When replacing a cutter wheel tooth,
replace the tooth and nut as a set and
use anti-seize on the threads.
SP7015TRX SERVICING CUTTER WHEEL
42