Carlton SP7015 TRX Owner's Manual page 33

HYDRAULIC CONTROLS
 A series of hydraulic controls are located
on the machine and radio transmitter,
which are clearly marked for use. There
are four operating and positioning
functions on the machine and remote
transmitter, the machine detail is shown
below. To operate push the toggle
switch in the direction of the command
you want to perform.

Use both controls in the same direction
(Fwd/Fwd or Rev/Rev) to move machine
forward or reverse. The radio transmitter
has a switch (BOTH TRACKS) that will
move both tracks at the same time in the
forward or reverse directions.

Use controls opposite (Rev/Fwd or
Fwd/Rev) of each other to turn machine
either right or left. When rotating the
machine, try not to leave one track
stationary while rotating the other one
around it as this could cause the machine to
jump a track. If it is desired to spin the
machine, counter-rotate the tracks.
TRACK WIDTH

Use the Track Width control to extend the
track width for more stability in positioning
and during grinding or to retract the track
width for maneuvering the machine through
tight places. If equipped with scape blade,
the scrape blade must be switched to off
position. Use the scrape blade switch on
control panel to adjust track width.
SP7015 TRX MACHINE CONTROLS
13