Carlton SP7015 TRX Owner's Manual page 42

 Start engine. (Follow directions in the
MACHINE CONTROLS section
depending on the engine your machine is
equipped with). If the engine doesn't
start right away and you have to restart
it, turn the key switch OFF and back
ON. Make sure the light on the
transmitter is still on, and restart the
engine by turning the key. If you lose the
connection (light off), repeat the
procedure from the beginning and
perform each step exactly as described.
 Start engine at half speed and allow
sufficient time for oil to circulate before
proceeding. Test controls for proper
operation.
 Position machine at stump with cutter
wheel a slight distance away from
stump. Do not engage cutter wheel
when positioning machine near stump.
Hitting the stump with the cutter
wheel running will break the Poly
®
Chain belt.
 Reduce engine speed to idle.
 Put machine flow control in low. Cutter
head positioning functions only operate
in low flow. (See Machine Controls
section.)
 Raise cutter head clear of stump.
 Engage cutter head drive belts by lifting
the engine slide lock and raising the
engagement handle to slide the engine
forward and engage the cutter wheel.
DO NOT ENGAGE OR
DISENGAGE BELT AT HIGH
ENGINE SPEED; PERSONAL
INJURY AND MACHINE DAMAGE
MAY OCCUR.
 Increase engine speed to full. Test
controls for proper operation, speed, and
unobstructed movement.
SP7015 TRX MACHINE OPERATION
KUBOTA KOHLER
22