Carlton SP7015 TRX Owner's Manual page 70

 You can now remove the bearing
supported stub shaft plate. Remove the
bolts holding the shaft plate to the
engine. There are eleven 10MM bolts to
remove. Pull the plate straight off.
 There are two threaded holes that can be
used to push the shaft plate off the
engine mount. Insert two of the bolts
that were removed from the stub shaft
plate and slowly screw them in until the
plate breaks loose. Leaving a couple of
bolts screwed in slightly may help to
keep the assembly from dropping when
separated from the engine.
 Remove the coupling plate. There are
eight 10MM bolts holding this plate to
the flywheel. These bolts had LocTite
blue applied before installation.
 When parts have been removed, clean
the engine flywheel with a cleaning
solvent and check for burrs around the
holes and on the surface of the flywheel.
Use a very fine sand paper to remove
any burrs.
SP7015 TRX

SERVICING STUB SHAFT
50