Carlton SP7015 TRX Owner's Manual page 30

DAILY CHECKS SHOULD BE PERFORMED BEFORE STARTING THE ENGINE FOR
THE DAY. DO NOT INSERT KEY INTO ENGINE UNTIL ALL CHECKS HAVE BEEN
COMPLETED.

Check engine oil at dipstick. Engine must be
level. Boom in raised position will not affect
the engine position; machine must be on level
ground. Add recommended oil, as required.
(See Engine Owners' Manual.)

Check fuel filter for debris or water.

Replenish fuel tank with fresh fuel.

Check condition and tightness of drive belts.
(See Servicing Belts section)
stretch and become loose as machine runs.
Check belt tension often when belts are
new.

Check for any loose, broken or missing teeth
and pockets.

Inspect bolts, hydraulic fittings, wiring
harnesses, hoses, and equipment for tightness,
wear, or leakage. Replace if necessary.

Inspect dry air filters. REPLACE, if necessary,
WITH FACTORY AIR FILTER ONLY (see
Maintenance Section for part numbers). Do not
blow out or tap on ground. Follow engine
manual procedure for removal and replacement.
Because of the environment of a stump grinder,
air filters need to be inspected and replaced more
often than the engine manufacturer recommends.

Replace inner safety filter when dirty or when
the outer air filter has been changed 3 times. Do
not blow out the inner safety filter or tap on
ground. Do not allow dirt to get into engine
when removing filters. Dirt ingestion will cause
engine failure and is not warranted.

Check hydraulic oil level. A sight glass is
located on the tank. Add oil if required. Do not
fill tank full, the oil will expand and spill out in
hot climates.

Grease jackshaft and boom bearings daily,
apply only 2 to 4 shots of grease. Do not over
grease.

Cutter wheel shaft bearings must be purged
with grease daily. Purge until clean grease is
seen.

Check the condition of the tracks and adjust
tension if necessary (see Maintenance section).
SP7015 TRX
New belts will
DAILY CHECKLIST
ENGINE SITTING LEVEL
JACKSHAFT & BOOM BEARINGS
CUTTER WHEEL BEARING
TRACK TENSION
10