Carlton SP7015 TRX Owner's Manual page 60

Hide thumbs Also See for SP7015 TRX:
Table of Contents

Advertisement

SAFETY
 NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
 CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
 ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
 DO NOT OPERATE A MACHINE WITHOUT A COMPLETE NUMBER OF
TEETH IN THE CUTTER WHEEL PROPERLY INSTALLED. EXCESSIVE
MACHINE VIBRATION WILL OCCUR CAUSING PREMATURE BEARING
FAILURE AND EQUIPMENT DAMAGE.
 PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
 There are thirty-two (32) teeth to a
complete set on the model SP7015. Two
(2) straight teeth, fifteen (15) left 45°
teeth and fifteen (15) right 45° teeth.
 A locking pin is provided to hold cutter
wheel in position during tooth removal
and re-installation.
 Locking pin will only lock on outer
teeth. NEVER PLACE YOUR HAND
ON THE CUTTER- WHEEL TO
HOLD IN PLACE WHILE
CHANGING TEETH.
 BE SURE TO REMOVE PIN
BEFORE OPERATING.
 A Tooth Setting Gauge (P/N - 0450111)
is provided with each machine for proper
tooth installation. Line all teeth up with
the inside edge of the groove in the
gauge. Set ALL teeth to this edge with
gauge against pocket, not against cutter
wheel. All teeth are set 1 ¼" out of the
pocket to the edge of the carbide.
SP7015TRX
SERVICING CUTTER WHEEL
40

Advertisement

Table of Contents
loading

Table of Contents