Carlton SP7015 TRX Owner's Manual page 41

Hide thumbs Also See for SP7015 TRX:
Table of Contents

Advertisement

STARTING - READ THIS MANUAL, ALL MACHINE DECALS, AND THE ENGINE
MANUAL BEFORE STARTING.
 Check all fluids before starting.
 Drive belts (cutter wheel) must be disengaged before starting.
 Inspect all connections, teeth, tracks, etc. (See Daily Checklist).
 Avoid transversing slopes. Ascend/descend hills straight up & down.
 DO NOT OPERATE THE ENGINE AT AN ANGLE GREATER THAN 25° OR
SEVERE ENGINE DAMAGE WILL OCCUR. PROPER ENGINE OIL LEVEL MUST
BE MAINTAINED TO ACHIEVE MAXIMUM ANGLE OF OPERATION OF 25°. (See
Engine Owner's Manual for proper oil level.)
 DO NOT OPERATE AROUND WATER, GAS, POWER OR PHONE LINES. IF IN
DOUBT, CHECK BEFORE GRINDING.
 WEAR FACESHIELD AND HEARING PROTECTION.
 KEEP CLEAR OF CUTTING WHEEL AND MOVING MACHINE PARTS.
 KEEP SPECTATORS AWAY.
 THE CUTTER WHEEL MUST BE
DISENGAGED BEFORE STARTING
THE MACHINE.
 The SP7015 TRX stump grinder is a radio
control machine. To start the engine and
radio control transmitter, follow these
instructions.
 Turn the ignition key switch to ON, the
machine switch to Remote On, and make
sure the flow switch is in the LOW
position and in AWD if equipped. Flip the
toggle switch to PARK if equipped with a
Kubota (see MACHINE CONTROLS
section).
 On the transmitter, press the E-STOP
button down.
 Toggle any switch on the transmitter.
 Twist the E-STOP button clockwise to
release. Release the E-STOP button
within 10 seconds to power up or the unit
will power down. When the transmitter is
operating there is a yellow light that will
be flashing, the light is indicated in the
picture at the right. (Read the radio
control manual for more information on
the meaning of different lights and colors.)
If the transmitter doesn't start, check the
transmitter for stuck switches; it will not
start with a switch in the ON position.
SP7015 TRX
MACHINE OPERATION
FLOW SWITCH –
LOW POSITION
PUSH SWITCH UP
TO REMOTE ON
BATTERY LOW /
FAULT LIGHT
TOGGLE ANY
E-STOP BUTTON
SWITCH
A YELLOW LIGHT
WILL BE FLASHING
WHEN RADIO IS
SENDING SIGNALS
TO THE RECEIVER
21

Advertisement

Table of Contents
loading

Table of Contents