Servicing Stub Shaft - Carlton SP7015 TRX Owner's Manual

SAFETY
 NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
 CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
 ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
 PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
 The most service you should have to do
for the bearing supported stub shaft is
to grease it properly. The bearing grease
fitting is easily accessible behind the V-
belt guard. Another grease fitting is on
the end of the stub shaft to grease the
splines in the coupling. Follow the
instructions in the Machine Maintenance
section for frequency and application of
grease. Also see the Lubrication Chart.
 If the bearing supported stub shaft
should fail for any reason, these are the
procedures for replacement. First
remove the V-belt following the
instructions in the Servicing Belt Section
of the manual. Remove the engine belt
keepers instead of just loosening the
bolts and lay aside to put on new stub
shaft plate assembly.
SP7015 TRX

SERVICING STUB SHAFT

BEARING SUPPORTED STUB SHAFT
GREASE FITTINGS
REMOVE V-BELT GUARD COVER
AND FOLLOW INSTRUCTIONS FOR
REMOVING V-BELT.
48