Carlton SP7015 TRX Owner's Manual page 47

Always clean tip of grease gun fitting and grease fitting on machine before attaching hose
to prevent dirt from being forced into machine parts.
 Grease the bearing supported stub shaft every
1000 hours of operation using Texaco
II grease. The grease fitting is easily accessible
behind the V-belt guard. Apply grease using a
hand held grease gun until the pin extends from
the pressure relief valve (located 180from
grease fitting on the bearing). Wipe off excess
grease. Excess grease will attract dirt.
 A grease fitting is on the end of the stub shaft to
grease the spline coupling. Apply 2 to 3 shots
of grease approximately every 1000 hours of
operation. Wipe off excess grease. Excess
grease will attract dirt. DO NOT over
grease, over greasing could cause a hydraulic
type lift on seals.
Kubota and Kohler
SP7015 TRX
Starplex

GREASE APPROXIMATELY EVERY 1000
HOURS OF OPERATION
MACHINE MAINTENANCE
PIN
Deutz
27