Carlton SP7015 TRX Owner's Manual page 34

LIFT (Cutter Wheel)
(Shown as CUTTER HEAD –UP/DOWN on radio
transmitter.)
This switch will move the cutter head up and
down. The cutter head must be raised for
ground travel to the stump and must be
lowered in the rest mode or to be
transported. The cutter head must be raised
to start cutting at the top of the stump and
lowered gradually to remove the stump
completely below the ground.
HYDRAULIC SCRAPE BLADE
(Optional)
(Shown as BLADE –UP/DOWN on
radiotransmitter.)
 This switch will move the scrape blade
up and down.
SWING
(Shown as CUTTER HEAD –RIGHT/LEFT
on radio transmitter.)
 The swing switch will rotate the cutter
head to the left and right to cut across
the stump.
GROUND SPEED ADJUSTMENT
VALVE
 Located on the rear side of the control
box, this valve controls ground (travel)
speed. Adjust ground speed for fast and
slow operation. Turn the valve
clockwise to increase speed and counter-
clockwise to go slower.
SP7015 TRX MACHINE CONTROLS
GROUND SPEED
ADJUSTMENT
14