Carlton SP7015 TRX Owner's Manual page 71

 Replace any parts found defective or
worn. Put stub shaft coupling plate onto
the flywheel. The plate is attached using
eight 10MM-1.5 x 20MM bolts with a
lock washer. Put LocTite
on the end of the bolt and lightly tighten
all bolts. When all bolts have been
inserted and lightly tightened, torque all
bolts to 35 ft. lbs.
 Put anti-seize (coupling lubricant) on the
inside of the coupling. Line up external
splines with the coupling ID and slide
the stub shaft plate into place.
 Make sure the grease fitting is on the top
of the assembly. Replace the 10MM-1.5
x 30MM bolts and torque to 35 ft. lbs.
There are eleven bolts holding the plate
to the engine.
 Remove the grease fitting and replace
with the grease fitting extension supplied
with the machine.
SP7015 TRX
242 (blue)

SERVICING STUB SHAFT
GREASE
FITTING UP
51