Carlton SP7015 TRX Owner's Manual page 51

COMPLAINT
Roar in machine when cutter
wheel is engaged.
Traction loss of power.
Bearing will not take grease.
Cutter head swings faster one
way than the other.
Track too loose.
For all Radio Transmitter or Receiver problems, see the Radio Control
Manual included at the back of this manual.
SP7015 TRX
CAUSE
Belt guards rubbing on

jackshaft or cutter wheel
shaft.
Jackshaft or cutter wheel

bearings going bad.
 Relief valve set too low.
 Hydraulic motor worn.
 Grease fitting clogged.
 Counter balance valve is
out of adjustment.
 Tensioning cylinder too
low on grease.
DO NOT OVER GREASE
TRACKS WILL BOW
TROUBLESHOOTING GUIDE
CORRECTION
Re-position guards away

from shafts.
Replace bearings.

 Increase relief valve
pressure by turning relief
valve screw inward.
 Replace Hydraulic motor.
 Replace fitting
 Adjust counter balance
valve to equalize swing
speed.
 See Maintenance Section
on Tensioning Tracks.
31