Lubrication Chart - Carlton SP7015 TRX Owner's Manual

 The model SP7015 TRX, as well as all of
our machines, is built to be a rugged
performer. Your new machine is sturdy
and our design goals are simplicity and
reliability.
Lubrication Schedule
 Use Texaco® Starplex II grease.
CARLTON PROFESSIONAL
TREE EQUIPMENT - MODEL SP7015 TRX
- ENGINE SLIDE
- ENGAGEMENT LINKAGE
- TRACK TENSIONING CYLINDER - TRACK TENSIONING CYLINDER
- TRACK FINAL DRIVE
- BEARINGS
- Pivot Table Bearing
- Boom Bearings
- Jack Shaft Bearings
- Cutter Wheel Bearings
- Bearing Supported Stub Shaft
- Stub Shaft End for Coupling-Deutz
- Stub Shaft End for Bearing Support-Kubota
ENGINE
REFER TO ENGINE MANUFACTURERS MANUAL FOR PROPER ENGINE SERVICING
SP7015 TRX

LUBRICATION CHART

 A regularly scheduled maintenance
program will pay big dividends in machine
life, performance and avoided downtime.
Special Comments
1-2 shots
1-2 shots
Give a few pumps using a standard hand held grease
gun when track gets loose.
Change after initial 200 hours. Change every 1000 hours or year
whichever comes first after that. Only use SAE 30 CD OIL (SYNTHETIC)
Every 100 hours of operation or at least
every 6 months when not in use
2-4 shots
2-4 shots
Purge bearings daily
Every 1000 hrs of operation apply grease until the
pin on the opposite side of the stub shaft extends
Grease approximately every 1000 hrs. of operation
2 - 3 shots of grease
Grease approximately every 1000 hrs. of operation
2 - 3 shots of grease
DO NOT OVER GREASE!
44TR-8_F (6/15) KJL)
29