Machine Controls - Carlton SP7015 TRX Owner's Manual

OPERATION – WIRELESS
 THE CUTTER WHEEL MUST BE
DISENGAGED BEFORE STARTING
THE MACHINE.
 To start the engine and radio control
transmitter, follow these instructions.
 Turn the ignition key switch to ON, the
machine switch to Remote On, and
make sure the flow switch is in the LOW
position and in AWD if equipped. Flip
the toggle switch to PARK if equipped
with a Kubota (see previous page).
 On the transmitter, press the E-STOP
button down.
 Toggle any switch on the transmitter.
 Twist the E-STOP button clockwise to
release. Release the E-STOP button
within 10 seconds to power up or the
unit will power down. When the
transmitter is operating there is a yellow
light that will be flashing, the light is
indicated in the picture at the right.
(Read the radio control manual for more
information on the meaning of different
lights and colors.) If the transmitter
doesn't start, check the transmitter for
stuck switches; it will not start with a
switch in the ON position.
 Now start the engine (See previous
page). If the engine doesn't start right
away and you have to restart it, turn the
key switch OFF and back ON. Make
sure the light on the transmitter is still
on, and restart the engine. If you lose
the connection (light off), repeat the
procedure from the beginning and
perform each step exactly as described.
Test controls for proper operation.
 The E-STOP button turns off the
transmitter and the machine when it is
pressed down.
 When the Flow switch is toggled up to
HIGH, it only operates when the Travel
function is being used.
SP7015 TRX

MACHINE CONTROLS

FLOW SWITCH –
LOW POSITION
PUSH SWITCH UP
TO REMOTE ON
LOW BATTERY /
FAULT LIGHT
TOGGLE ANY E-STOP BUTTON
SWITCH
NEVER WELD ON A MACHINE WITH
RADIO CONTROLS WITHOUT FIRST
DISCONNECTING THE RECEIVER WIRE
HARNESS, OTHERWISE THE RADIO
RECEIVER WILL BE DESTROYED.
A YELLOW LIGHT
WILL BE FLASHING
WHEN TRANSMITTER
IS SENDING SIGNALS
TO THE RECEIVER
12