Carlton SP7015 TRX Owner's Manual page 67

REPLACING HYDRAULIC PUMP
 Engine must be shut off.
 Remove key & disconnect battery cable.
 Make sure that hydraulic oil is cool and
that pressure is relieved from the lines.
 Disconnect hydraulic lines from pump
and cap them, mark which line goes
where to reconnect correctly.
 Remove bolts holding pump to engine.
 Replace pump and tighten bolts.
 Uncap and reconnect hydraulic lines
paying attention to how they were
marked.
 Recheck oil supply in reservoir,
replenish if necessary.
HYDRAULIC HOSES & FITTINGS
 Inspect hydraulic hoses and fittings daily
for leaks, tightness, wear, or damage.
Repair or replace as needed.
 FLUID UNDER PRESSURE CAN
PENETRATE THE SKIN AND CAUSE
SEVERE INJURY. CHECK HOSES
AND FITTINGS USING A BOARD
OR CARDBOARD; DO NOT USE
HAND OR FINGER. SEEK
IMMEDIATE MEDICAL ATTENTION
IF SKIN IS PENETRATED. ALWAYS
WEAR EYE PROTECTION.
SP7015TRX SERVICING HYDRAULICS
47